- Super small size (not including its case): 32.0*19.6*7.2mm(Type B)
- Very light (not including its case and the integrated receiver): 2.9g (Type B), it is 6.4g with case
- Working voltage: Type B : 3.3~4.5V or 5~10V;
- 12M/10PPM Crystal Oscillator;
- Receivers it supports: PPM，DSM2，DS，SBUS；
- Option for integrated with DSM2 compatible 7CH receiver;
- Type B and Type X is with DCDC boost (output 5V/500Ma),it can supply power for outside device;
- The integrated output 5V/500mA LDO can supply power for outside device;
- Independent ports for IIC, GPS, PPM/DSM/SBUS receivers;
- Notes: Type B and Type X is with 1.5mm pitch port.
Size for SCISKY 32-B flight control board (unit: mm):
Ports for SCISKY 32-B flight control board:
Voltage option
When the pads inside the blue square box on the following picture are used, the working voltage will be 3.3V~4.5V (1S lipo is recommended); When the pads inside the red square box are used, the working voltage will be 5.0V~10.0V (2S LIPO is recommended or power supplied through an outside BEC).
LED lights meaning:
Red LED—power; blue LED—flying mode; green LED—unlock;
How to connect a receiver:
Type A, type B gets a RX-S port (1.25mm 3P) which is special for connecting an outside receiver, it supports signal input of PPM, DSM2/DS, SBUS (note 1), it also support 3.3V or VIN output (Note 2), in order to connect an outside receiver, short connecting pads on RX-S and changing type of receiver on GUI at the same time is the way. Besides, type A, type B support integrated DSM2 compatible 7CH receiver (Note 2)
Notes:
1) Type A and type B doesn’t support signal reverse
2) When output is VIN, and VIN>5.5V, please make sure if the outside receiver supports 5.5V or more, or the outside receiver may be burnt;
3) As it gets an integrated receiver, as soon as the integrated receiver is set to output banned (RF circuit of the integrated receiver won’t work at the moment), the outside receiver can work without problem.
It comes the following cables:
